Car Mechanic Simulator 2018: Order 24 - Royale Crown

This is an order in Car Mechanic Simulator 2018, in which you repair a Royale Crown. Here, you will find a list of actions to be performed during this order.

• Shopping list
• Walkthrough

Shopping list

Replacement list:

1. Battery
2. ABS Pump
3. ABS Module
4. Brake Servo
5. Fuel Pump
6. Air Filter
7. Oil Filter (I4)
8. Ignition Coil x3
9. Spark Plug x3
10. Engine Head Cover (I4)
11. Throttle (I4)
12. Intake Manifold (I4 DI)
13. Belt Tensioner
14. Idler Roller A
15. Serpentine Belt A
16. Serpentine Belt B
17. Power Steering Pump (I4)
18. Alternator
19. Water Pump (I4)
20. Timing Belt
21. Timing Belt Cover (I4)
22. Cam Gear
23. Camshaft
24. Crankshaft Pulley (I4)
25. Cranskshaft (I4)
26. Piston with Conrod x2
27. Engine Head (I4)
28. Engine Block (I4)

Exhaust:

1. Turbocharger
2. Exhaust Manifold (I4 TURBO)
3. Front Exhaust Section (TURBO)
4. Exhaust Pipe
5. Middle Muffler
6. Catalytic Converter
7. Rear Muffler (I4)

Walkthrough

Begin with removing the timing components, then the engine head

Your old pal Royale Crown is back in the workshop. Like in the previous story order, you'll have to replace the crankshaft, but also the entire engine block. Luckily, this time you're working on an in-line engine, which makes the whole process a lot shorter. Suspension and brakes are good. In short, you'll be dismantling the entire engine and putting it back together. Again.

Looking from the timing, the old spark plug and ignition coil may remain over the third piston. Pistons that need to be replaced are numbers 2 and 4. Don't forget to tighten them from below and install the oil pan before you think of changing the oil.

Car Mechanic Simulator 2018

July 28, 2017

Rate It!

• Overview
• Guide