Car Mechanic Simulator 2018: Order 29 - Mayen M8

In this order in Car Mechanic Simulator 2018, you will have to repair an Mayen M8. In the next section, you will find a detailed description of the steps you need to take to complete the task.

• Shopping list
• Walkthrough

Shopping list

Replacement list:

1. 6x Spark Plug (buy 8)
2. Alternator
3. Air Filter
4. Oil Filter (V8)
5. Radiator A
6. Radiator Fan Housing B Fan 1
7. Radiator Fan Housing B Fan 2
8. Radiator Fan Housing B
9. 5x Piston with Conrod
10. 4x Rod Cap
11. Engine Block (V8)
12. Timing Cover (V8)
13. Crankshaft B (V8)
14. Water Pump (V8)
15. Crankshaft Pulley (V8)
16. Water Pump Pulley
17. Power Steering Pump (V8)
18. Oil Pan (V8)
19. Serpentine Belt A (V8)
20. Serpentine Belt B (V8)
21. 2x Timing Belt (V8)
22. Belt Tensioner
23. Idler Roller A
24. 4x Idler Roller B

Exhaust:

1. 2x Rear Muffler (V8)
2. 2x Exhaust Pipe
3. 2x Middle Muffler
4. 2x Catalytic Converter
5. 2x Front Exhaust Pipe (V8)
6. 2x Exhaust Manifold (V8)

Walkthrough

The pistons highlighted in green have to be replaced

Again, you need to disassemble the whole engine, in order to get to the engine block. Keep track of which pistons have to be replaced: from the side of the brake servo - all but the one in the right corner. On the other side: two pistons in the corners. Ignition plugs should be bought in a set (8 plugs) - replace all, to avoid a mistake (they're cheap - 6$ a plug). This time, you will also have to fit the pistons with new rod caps. Looking from the side of the oil filter, the above picture shows the caps that have to be replaced.

Replace only the A roller that's fitted at the A belt - leave the one at belt B

When assembling the engine, note that there are two A idler rollers, but only one has to be replaced - the one with the serpentine belt A; it'll have to be installed after the belt is in place.

Car Mechanic Simulator 2018

July 28, 2017

Rate It!

• Overview
• Guide