Car Mechanic Simulator 2014: Order 48 - Revton Van

CAR: Revton Van

TARGETS:

1. Perform general inspection of an engine
2. Replace all worn parts
3. Check the oil

REWARD: 1000 USD

PARTS:

• Idler Pulley - 100 USD
• Timing Belt - 120 USD
• Serpentine Belt - 100 USD
• Belt Tensioner - 150 USD
• Oil change - 100 USD + cost of new oil ca. 10 USD

You have to do a typical, routine car maintenance - check condition of the engine and replace worn parts, check the oil as well. Go to the Engine - inspect view and check condition of all elements located by the engine (valvetrain, air subsystem, oil filter) by using the Examine conditions tool. Use the OBD Link to test the ignition subsystem. In result - replaced should be:

• Idler Pulley
• Timing Belt
• Serpentine Belt
• Belt Tensioner

Entire valvetrain to the trashcan...

Buy new models of these parts and start replacing:

• Remove Serpentine Belt.
• Remove Belt Tensioner.
• Remove Timing Belt.
• Remove Idler Pulley and go to the Assemble Mode.
• Assemble new Idler Pulley.
• Assemble new Timing Belt.
• Assemble new Belt Tensioner.
• Assemble new Serpentine Belt.

Also the oil should be changed:

1. Use the Car Lifter and go to the view of the engine from below with the Engine - inspect option.
2. Find Oil Pan located on the bottom of the engine.
3. Find Oil Drain Plug, twist it off and flush the old oil.
4. Lower the car with the Car Lifter and go to the Engine - inspect view mode.
5. Twist off Engine Oil Fill Plug.
6. Click on the oil jerrycan and pour the oil to the engine for a few seconds.
7. Put out Oil Dipstick and check level of oil - point that connects gold and silver field should be as close to the scale's middle as possible.

Car Mechanic Simulator 2014

January 24, 2014

Rate It!

• Overview
• Guide