Car Mechanic Simulator 2014: Order 68 - Revton Wind

CAR: Revton Wind

TARGETS:

1. Renovate the engine

REWARD: 4000 USD

PARTS:

• Timing Belt - 120 USD
• Serpentine Belt - 100 USD
• Belt Tensioner - 150 USD
• 4x Spark Plug - 120 USD
• Air Flow Meter - repair ca. 210 USD, new part 450 USD
• Ignition Wires - 150 USD
• Air Filter - 35 USD
• Oil Filter - 50 USD
• Battery - 350 USD
• Oil change - 100 USD + cost of new oil ca. 10 USD

Client comes to you in car with very old engine - your task is to completely renovate it. In addition to that you have also to change oil. Perform the electronics test with the OBD Link option and then turn on the Show parts conditions mode. After tests following parts qualify for replace:

• Timing Belt
• Serpentine Belt
• Belt Tensioner
• 4x Spark Plug
• Air Flow Meter
• Ignition Wires
• Air Filter
• Oil Filter
• Battery

Prepare new models of mentioned parts (or repair them - that applies to air flow meter) and begin the great renovation of the engine:

Timing belt, serpentine belt, belt tensioner:

• Go to the Engine - inspect view mode when the car stands on the ground.
• Remove Serpentine Belt V6.
• Remove Belt Tensioner.
• Remove Timing Belt and assemble a new part.
• Assemble new Belt Tensioner.
• Assemble new Serpentine Belt V6.

Spark plugs, ignition wires:

• Remove Plastic Engine Cover.
• Unplug Ignition Wires.
• Twist off all four Spark Plugs and replace them with new parts.
• Assemble new Ignition Wires.
• Assemble Plastic Engine Cover.

Air flow meter, air filter

1. Remove Air Flow Tube.
2. Remove Air Flow Meter.
3. Twist off Air Filter Cover.
4. Put out worn Air Filter and assemble a new part.
5. Assemble new Air Flow Meter.
6. Assemble Air Flow Tube.

Oil filter:

• Raise Hood and go to the Engine - inspect view mode.
• Turn on the Disassemble Mode.
• Remove Oil Filter Cap.
• Put out Oil Filter.
• Turn on the Assemble Mode.
• Put in new Oil Filter.
• Assemble Oil Filter Cap.

Battery:

1. Raise Hood and go to the Engine - inspect view mode.
2. Put out Battery and replace it with a new one.'

You have to change oil in the end:

1. Use the Car Lifter
2. Go to the view of the engine from below with the Engine - inspect option.
3. Find Oil Pan located on the bottom of the engine.
4. Find Oil Drain Plug, twist it off and flush the old oil.
5. Lower the car with the Car Lifter and go to the Engine - inspect view mode.
6. Twist off Engine Oil Fill Plug.
7. Click on the oil jerrycan and pour the oil to the engine for a few seconds.
8. Put out Oil Dipstick and check level of oil - point that connects gold and silver field should be as close to the scale's middle as possible.

Car Mechanic Simulator 2014

January 24, 2014

Rate It!

• Overview
• Guide